Kn Global Filtration Washable Reusable Panel Filter Washing Instructions

K&N Washable/Reusable Panel Filter Washing Instructions

Maintain peak performance and extend the life of your K&N Washable Filters by following the steps below. This procedure is designed for safe, effective cleaning using only water—no chemicals or detergents are required. Always follow K&N’s recommended service intervals. Regular maintenance helps ensure airflow efficiency and optimal performance of your filtration system.

TOOLS NEEDED

  • Cold water supply
  • Pressure regulator set to 40psi
  • Standard garden hose
  • Spray nozzle on “full” setting
  • Riser/Prop for drainage
  • Timer or stopwatch
  • Fan for optional gentle airflow during drying

WATCH THE PANEL WASHING INSTRUCTIONS VIDEO

Maintain your K&N Panel Filter with ease—watch the video or use the instructions below.

STEP 01 – PREPARE THE AREA

  • Choose a clean outdoor space with good drainage for runoff water.
  • Ensure water supply is connected through a pressure regulator set to 40psi.

STEP 02 – ADJUST THE PRESSURE & SPRAY SETTINGS

  • Regulate water pressure to 40psi.
  • This avoids filter media damage and maintains optimal cleaning effectiveness.
  • Do not exceed 40psi.
  • Set the nozzle to the circular “full” setting.
  • This produces a soft, circular spray ideal for even cleaning.
  • Avoid jet, stream, or pinpoint settings that may harm filter media.

STEP 03 – PROP-UP FILTER FOR DRAINING

  • Prop up the filter from the rear with a dowel or PVC to ensure water and debris drain effectively.
  • Ensure the filter pleats run horizontally.

STEP 04 – WASH WITH SLOW, DELIBERATE FLUSHING

  • Orient the water-stream oblique to the filter media.
  • With a continuous sweeping motion, flush the filter media water in a parallel to the direction of the pleats.

STEP 05 – GETTING THE FILTER CLEAN

  • You’ll see dirty water runoff initially transitioning to clear, clean water as the filter becomes clean.
  • Total wash time: 90 seconds. Dedicate 90 seconds to each Panel filter.

STEP 06 – DRYING

  • Allow filters to air dry for 12 hours in a clean, indoor location. Maintain ambient humidity and a room temperature between 70–85°F.
  • Use a gentle fan to circulate air around the filter, but do not use heat or
    direct airflow into the filter.

AVOID THE FOLLOWING TO PREVENT DAMAGE TO THE FILTER

  • Do not use chemicals or detergents.
  • Do not use a pressure washer.
  • Do not dry using heat guns, ovens, or direct sunlight.
  • Do not use an air gun or compressed air.
  • Do not exceed 40psi.

Read more from K&N